Tiger Mowers SIDE FLAIL ASEMBLIES JD 5085M-105M - Manual (Page 32)

ASSEMBLY
Assembly Section 2-6
CABLE CONTROL LEVER STAND
Place the cable control bracket on the floor so that the bracket is 2-1/2” from the side edge of
the door, and 4-3/8” in front of the rear edge of the door. See images below. Be sure that the
location of the stand will allow the operation of all control levers in the tractor and that the door
will not strike the stand when shut. Before drilling double check location of the stand for proper
placement of holes. Make sure that all cables and wires are clear of the area before drilling holes
to mount the stand. Drill 3 holes to match control bracket as shown below and secure with cap-
screws and nylock nuts noted in parts section..
The rubber boot under the rear window can be cut in a cross hair pattern and if necessary the
bottom cut through to allow it to slip over the cables and back into position. These cables will be
routed to the lift valve mounted on the valve mounting plate, and should not have any sharp
bends or kinks in them. Secure cables with zip ties and apply RTV sealer in and around individ-
ual cables, inside and outside of the cab for a water tight seal. Do not allow excess cable to
hang unsecured on the outside of the cab.
(ASM-JD-0087) .