Tiger Mowers SIDE FLAIL ASEMBLIES JD 5085M-105M - Manual (Page 39)

ASSEMBLY
Assembly Section 2-13
HOSE AND WIRE ROUTING
Attach two clamps to the right rear wheel well for proper hose/wire routing. Drill one
hole for each clamp. Use the lower rear corner of the wheel well as an origin for
measuring. The holes should be 10mm or 3/8” reamed to accept 3/8” hardware.
Measure along the back edge of the wheel well 6” from the origin. Use a square to
measure 2-½” up, from the last mark. Refer to the image below to see the first hole.
The second hole should run parallel to the bottom edge of the wheel well. Mark the
hole 22” from the origin and 3-½” from the bottom edge. Use the images below for
reference.
NOTE: DO NOT CUT INTO TUBES / HOSES / WIRES WHEN DRILLING
THROUGH METAL OR PLASTIC!.
(ASM-JD-0068)
Place as many hoses in the clamp that will fit without compromising pressure. Then
secure the (2) HOSE CLAMP (06520013) to the holes drilled with (1 EACH) CAPSCREW,3/8
X 1 NC (21630) and (1 EACH) NYLOCK NUT,3/8 NC (21627). The hoses that don’t fit into
the clamp are to be secured to the others with zip-ties. For protection of hoses in contact with
metal edges, wrap hoses with spit hose sections and fasten with hose clamps or zip ties as
needed.