Tiger Mowers SIDE FLAIL ASEMBLIES JD 5085M-105M - Manual (Page 47)

ASSEMBLY
Assembly Section 2-21
MOWER MOUNTING
Check that all grease zerks have been installed in the draft beams pivot arm, left linkage arm,
right linkage arm, and cylinder mounting ears.
Using a clevis pin and roll pins, connect the pivot arm to clevis on draft beam. NOTE: Make
sure the longer distance between the cutout and the end of the pivot arm is closest to the draft
beam pivot ears on the center tube as shown in the diagram below. Also make sure the cutout
on the pivot arm faces into tube of draft beam.
(ASM-C-0077)
Slide other end of pivot arm with short distance between the cut-out and the end of the pivot
arm, into the cylinder clevis. Next, line up the holes of the left and right lift linkage arms outside
of the cylinder clevis holes. Connect with linkage pin, shims (as required), boss, cap-screw,
lock-washer and hex nut as shown.
To connect the bonnet to the draft beam, slide the extension arms of the draft beam between
the mounting ears on the inner end of the bonnet. Line up the holes and secure with swivel pin,
cap-screw, lock-washer, and hex nut (both sides). See parts book illustration.
Next, slide the left and right linkage arms up to the slotted ear on the side of the deck.
Secure with linkage pin, shims, boss, cap-screw, lock-washer and hex nut. See illustration in
Parts Section.