Trimble Outdoors 132 - Manual (Page 60)

5 Configuring the Receiver
6 0 DSM 132/132RS Receiver User Guide
When setting the baud rate, note the following:
• If you are using 19.2 k or 38.4 k, the input rate must match the
output rate.
• If Port A is operating at 19.2 k, Port B can operate at 1200,
2400, 9600, or 19.2k (not 38.4 k).
• If Port B is operating at 38.4k, Port A can operate at 1200, 2400,
9600 and 38.4k (not 19.2k).
To change the input or output settings:
1. From the Port A Config screen, press 2 until the Port-A
Input/Output screen appears:
2. Press 3 to activate the cursor.
3. Press 1 or 2 to change the value.
4. Press 3.
5. Repeat steps 3 and 4 until you have set all the required values.
6. Press 4 to save all the changes.
7. Press 2 to move to the next screen.
Selecting NMEA messages for output
Use this screen to select the NMEA messages output from the current
port. Only upper-case NMEA message types are output. The default
messages are GGA, GSA, VTG, and RMC.
åæ I RTCM 9600
8N1 0 NMEA 4800