Edit base position, Set from averaged positions – Trimble Outdoors 132 User Manual
Page 77
DSM 132/132RS Receiver User Guide 7 7
Configuring the Receiver 5
–
Press
1 or 2 to reject the new reference position. Press
4 to finish.
50.1
Edit base position
Set the receiver antenna to a particular location. Do this when the
antenna is on a surveyed location with known coordinates:
1.
Navigate to the Base Location screen.
2.
Press
3 to activate the cursor.
3.
Press
1 or 2 until Edit Base Pos is displayed.
4.
Press
4. The receiver displays three screens in succession,
showing the current latitude, longitude, and altitude:
–
To save the current coordinate value, press
4.
–
To change the reference coordinate value, press
1 or 2.
Press
3 to move between characters. Press 4 to save the
changes.
5.
Once you press
4 to accept the altitude, the receiver asks
whether or you want to accept the new reference position or not:
–
Press
4 to accept the new reference position.
–
Press
1 or 2 to reject the new reference position. Press
4 to finish.
50.1
Set from averaged positions
To determine the location of the receiver antenna, you can configure
the receiver to average the computed position over a period of time:
1.
Navigate to the Base Location screen.
2.
Press
3 to activate the cursor.
3.
Press
1 or 2 until Set From Ave is displayed.
4.
Press
3 to move the cursor to the right.