Trimble Outdoors 132 - Manual (Page 76)

5 Configuring the Receiver
7 6 DSM 132/132RS Receiver User Guide
50.3
View location
To view the current location of the receiver antenna:
1. Navigate to the Configuration / Base Stn Config / Base Location
screen:
2. Press 4 one or more times to view the current computed
reference position, latitude, longitude, and altitude.
Note – The reference position coordinates are in
latitude/longitude; the datum is WGS-84; altitude is referenced
to Mean Sea Level (MSL).
50.1
Set from here
To set the receiver antenna location, select the current computed GPS
position as follows:
1. Navigate to the Base Location screen.
2. Press 3 to activate the cursor.
3. Press 1 or 2 until Set From Here is displayed.
4. Press 4. The receiver displays three screens in succession,
showing the current latitude, longitude, and altitude:
– To save the current coordinate value, press 4.
– To change the reference coordinate value, press 1 or 2.
Press 3 to move between characters. Press 4 to save the
changes.
5. When you press 4 to accept the altitude, the receiver asks
whether you want to accept the new reference position or not:
– Press 4 to accept the new reference position.