TANDBERG 7000 MXP - Manual (Page 24)

D1335403_T7000_MXP_User_Manual
24
2.2 Connecting Cables
1. Power cable
Connect the system power cable to the correct country variant of the power cable. Connect this
cable to an electrical distribution socket.
2. Microphone cable
Connect the microphone cables to the microphones.
3. DNAM Audio Module - audio cable
Connect the RCA cable coming out of the bottom of the base to Audio out 1 on the codec.
4. Camera cable
Place the camera centrally on top of the monitor frame, in line with the front of the screen, after
connecting the 2 cables as shown below. Remove the protection paper which is placed behind
the front glass of the camera. The camera should be aligned with the front edge of the monitor
to ensure the IR-sensor in the camera can pick up signals from the remote control.
5a. ISDN cables - using BRI interface
Connect the ISDN cables to the ISDN sockets (S/T-interface) provided by the service provider.
Your main number will be the number associated with the socket to which ISDN cable number
1 is connected. (The system does not have a built-in network terminator. If your wall socket
provides you with an ISDN U-interface, you will need an NT1 between your system and your
ISDN line, see
Appendix 9 .)
5b. ISDN cable - using the PRI interface
If you are using the PRI interface, the E1/T1 cable should be connected to a CSU (Channel
Service Unit). You will need a CSU between your system and the PRI line from your network
provider, see
Appendix 7 .
5c. Other networks - using the External Network interface
If you are using other networks, please refer to chapter 4.8.1
ISDN/External/Leased E1/T1 and
Appendix 8 .
6. LAN cable
To use the system on LAN, connect a LAN cable from the Ethernet connector on the system to
your LAN.