Tyan Computer THUNDER N3600T - Manual (Page 14)

14
http://www.TYAN.com
2.04 – SAS Disable Jumper (JP1)
For external disable SAS controller
Installed: Disable
(Default)
Not installed: Enable (Default)
2.05 – OPMA card supporting select header (JP2)
When using other OPMA card, remove jumper
(Default)
When using TYAN OPMA card, install jumper
(default)
2.06 – Clear CMOS (JP3)
Normal
(Default)
Clear
Use this jumper when you have forgotten your
system/setup password or need to clear the system
BIOS settings.
How to clear the CMOS data
-
Power off system and disconnect the power
supply from the AC source
- Use jumper cap to close pin_2 and 3 for several
seconds to clear the CMOS
- Replace the jumper cap to close pin_1 and
pin_2 Reconnect the power supply to the AC
source and power on the system
2.07 – USB Front Panel Header (J2)
VCC 1 2 VCC
DATA- 3 4 DATA-
DATA+ 5 6 DATA+
GND 7 8 GND
KEY 9 10 NA