Tyan Computer THUNDER N3600T - Manual (Page 32)

32
http://www.tyan.com
Type B: SCREW RETENTION TYPE HEATSINK
1. After placing CPU back-plate and
adhesive interface material under
motherboard, place heatsink
retention frame on top of
motherboard. Align heatsink
retention frame screw hole with
backplate assembly standoffs. Place
heatsink inside plastic retention
bracket. Place metal clip over
retention frame tab. Repeat for other
side.
2. Insert screw through metal clip.
BE SURE METAL CLIP IS
LOCKED ONTO RETENTION
FRAME TAB.
3. Tighten screw through metal clip.
Repeat on the other side.
DO NOT OVER TIGHTEN.
Finishing Installing the Heatsink
After you have finished installing the heatsink onto the processor and socket,
attach the end wire of the fan (which should already be attached to the heatsink)
to the motherboard. The following diagram illustrates how to connect fans onto the
motherboard.
Once you have finished installing all the fans you can connect your drives (hard
drives, CD-ROM drives, etc.) to your motherboard.