TDK 3300 ICP - Manual (Page 17)

SpectraLink Corporation Setup and Administration—NetLink e340/i640 Wireless Telephone
Mitel Networks 3300 ICP and 5220 IP Phone emulation
PN: 72-1084-02-B.doc Page 17
more information on this mode.
Regulatory Domain
The Regulatory Domain will default to North America on the Wireless Telephone
display. FCC requirements dictate that the menu for changing the domain be available by
password, which in our case is the
LINE key. To change the domain, press LINE and then
enter the digits that represent the site’s domain. Note that both digits must be entered.
01 - North America
02 - Europe (except Spain and France); Japan (channels 1-13)
04 - Spain
05 – France
Note: as of this writing, Spain and France are adopting the general European Regulatory
rules. Check with your wireless LAN administrator or supplier for which domain to enter
in these countries.
Security
*NONE disables any 802.11 encryption or security authentication mechanisms.
WEP (Wired Equivalent Privacy) is a wireless encryption protocol that encrypts data
frames on the wireless medium allowing for greater security in the wireless network. If
WEP/Encryption is required at this site, you must configure each Wireless Telephone to
correspond with the encryption protocol set up in the access points. Select the entries
from the options below to enable the Wireless Telephone to acquire the system.
   
Set each of these options to match exactly the settings in your APs.
    Encryption codes display as they are entered. For security reasons codes
will not display when a user returns to the Admin menu, Encryption
options.
    Note that WEP may be set to “optional” at the AP if there are wireless
devices in use that do not have WEP capability. All wireless devices must
be upgraded to WEP capability for a fully secured WEP environment.
Authentication
Select either Open System or Shared Key .
WEP On/Off
Select either WEP Off or WEP On .
Key Information
Press the Right Arrow key to scroll through the options:
Default Key : Enter the key # specified for use by the WTs. This will be 1
through 4.
Key Length : Select either 40-bit or 128-bit depending on the key length
specified for use at this location.
Key 1-4 : Scroll to the key option that corresponds to the Default Key that
was entered above. Enter the encryption key as a sequence of hexadecimal