TDK 3300 ICP - Manual (Page 40)

SpectraLink Corporation Setup and Administration—NetLink e340/i640 Wireless Telephone
Mitel Networks 3300 ICP and 5220 IP Phone emulation
PN: 72-1084-02-B.doc Page 40
Message Description Action
Press End Call Your call has ended. Press the Power Off / End Call key
to return to standby mode.
Restart Command The Wireless Telephone received a
restart command from the supported
Mitel Networks VoIP solution. None. The Wireless Telephone
will automatically restart in a few
seconds.
Select License The correct protocol has not been
selected from the license set. Using the administrative menus,
select one license from the set to
allow the phone to download the
appropriate software.
Server Busy Wireless Telephone is attempting to
download from a TFTP Server that is
busy downloading other devices and
refusing additional downloads. None, the Wireless Telephone will
automatically retry the download
every few seconds.
SVP Service Rej. The NetLink SVP Server has
rejected a request from the Wireless
Telephone. The Wireless Telephone will restart
and attempt to re-register with the
SVP Server, which should fix the
problem. Report to your
administrator if it keeps happening.
System Locked
(with Busy Tone) NetLink SVP Server is locked. Try call again later, system has
been locked for maintenance.
System Busy
(with Busy Tone) NetLink SVP Server is busy or out of
resources. All call paths are in use, try call
again in a few minutes.
TFTP ERROR(x):yy A failure has occurred during a TFTP
software download. (x) = The file
number which was being
downloaded; yy is an error code
describing the particular failure.
Possible error codes are:
01 = TFTP server did not find the
requested file.
02 = Access violation (reported
from TFTP server).
07 = TFTP server reported "No
such user" error.
81 = File put into memory did not
CRC.
FF = Timeout error. TFTP server
did not respond within a specified
period of time.
Error code 01, 02 or 07 - check the
TFTP server configuration.
Error code 81, the Wireless
Telephone will attempt to
download the file again.
For other messages, power off the
Wireless Telephone, then turn it on
again to retry the download. If the
error repeats, note it and contact
SpectraLink Technical Support.
Updating Code… Wireless Telephone is downloading
new software into memory. None. When the progress bar fills
the display line the update
operation is complete on that file.
Updating … The Wireless Telephone is internally
updating its software images. None. The Wireless Telephone
may do this briefly after a
download. This is informational
only.