TDK 3300 ICP - Manual (Page 38)

SpectraLink Corporation Setup and Administration—NetLink e340/i640 Wireless Telephone
Mitel Networks 3300 ICP and 5220 IP Phone emulation
PN: 72-1084-02-B.doc Page 38
Message Description Action
DO NOT POWER
OFF The Wireless Telephone is in a
critical section of the software
update. None. Do not remove the battery
or attempt to power off the phone
while this is displayed. Doing so
may require the phone to be
returned to SpectraLink to be
recovered.
Duplicate IP The Wireless Telephone has
detected another device with its
same IP Address. If using DHCP, check that the
DHCP server is properly
configured to avoid duplicate
addresses.
If using Static IP, check that the
Wireless Telephone was assigned
a unique address.
Erase Failed Download process failed to erase the
memory in the Wireless Telephone. Operation will retry but may
eventually report the error "int.
error: 0F" Power cycle the phone.
Erasing Memory Wireless Telephone has determined
that a download should occur and is
erasing the current software from
memory. None. When the progress bar fills
the display line the erase operation
is complete.
Initializing … The Wireless Telephone is
performing power on initialization. None. This is informational only.
Internal Err. # # The Wireless Telephone has
detected a fault from which it cannot
recover. Record the error code so it can be
reported.
Turn the Wireless Telephone off
then on again.
If error persists, try registering a
different Wireless Telephone to
this telephone port.
If error still persists, contact
SpectraLink Technical Support and
report the error.
Network Busy All APs are full or busy. Try call again later.
No Host IP The Wireless Telephone is
configured for “static IP” (as opposed
to “use DHCP”) and no valid host IP
Address (the Wireless Telephone’s
IP Address) has been entered. Enter a valid IP Address in the
configuration settings or change to
“use DHCP”.
No IP Address Invalid IP. Check the IP Address of the
Wireless Telephone and re-
configure if required.
No PBX Response The Wireless Telephone tried to
send a message to the supported
Mitel Networks VoIP solution and
failed to get a response. Verify the supported Mitel
Networks VoIP solution is
operational and connected to the
network.