Topcom OG-T700 User Manual
Page 23
TOPCOM OGATECH OG-T700/Twin/Triple/Quattro
23
TOPCOM OGATECH OG-T700/Twin/Triple/Quattro
ENGLISH
To register any handset, the base must be put into a special registration mode:
1.
Press and hold the paging key
of the base for 6 seconds.
2.
The base will then emit a beeptone. The base is now ready to register a new handset.
You have 90 seconds after pressing the button to register a new handset.
After putting the base into registration mode, start the procedure on the new handset:
6.1.1 if your additional handset is a OGATECH OG-T700
3.
Enter the menu by pressing /OK
4.
Select REGISTER using the up and down
keys
5.
Press OK
6.
Select REG BASE using the up
and down
keys
7.
Enter a base number ( from 1 to 4 ). The flashing numbers are already in use.
8.
Enter the Base PIN code (0000 by default )
9.
Press OK. The handset will start searching for the DECT base
10.
If the handset has located the base, it will display the base identification number,
validate the base registration by pressing OK or stop by pressing
.
11.
If the handset does not locate the base, it will return to the standby mode after a few
seconds.
12.
Try again by changing the base number and check that you are not in a environment
where there is interference. Move closer to the base.
6.1.2 if your handset is another model
After starting the registration procedure on the base, refer to the handset manual to find out
how to register the handset. The handset must be GAP compatible.
The icon and the text "NOT REG" flashes on the display when the handset is not
associated with the base. When a handset is associated with a base, it is attributed a handset
number by the base. It is this number that is displayed on the handset after the name and
must be used for internal calls.
6.2
Removing a handset
You can remove a handset with a base to allow another handset to be registered
1.
Enter the menu by pressing /OK
2.
Select SETUP using the up
and down
keys
3.
Press OK
4.
Select DEL HANDSET using the up and down
keys
5.
Press OK
6.
Enter the 4 digit base PIN code
7.
Press OK
8.
Select the handset to be removed
9.
Press OK to validate
DECT GAP Profile only guarentees that basic calling-functions will work
correctly between different brands/types. There’s a possibility that
certain services (like CLIP) will not work correctly.