Topcom OG-T700 User Manual
Page 25
TOPCOM OGATECH OG-T700/Twin/Triple/Quattro
25
TOPCOM OGATECH OG-T700/Twin/Triple/Quattro
ENGLISH
7.1.1 Setting the base speaker volume
To change the volume during playback of incoming or outgoing messages, press
to
increase or
to decrease. The volume can be set from ‘0’-’9’. If the volume is set to the
lowest position there will be no audible output during call screening and during remote
interrogation, but there will be a level ‘1’ output for other operation.
7.1.2 Turning Answering Machine On/Off
If the answering machine is On, the
-LED on the base will light up continuously (or blink
when there are new messages) and the machine will automatically pick up the line after a
number of rings ( See 7.1.3 “Setting Number of Rings” ).
If the answering machine is Off, the
-LED on the base will not lit.
•
Press to switch On the answering machine.
•
A voice confirms the setting and playback the active OGM.
•
Press to switch Off the answering machine.
Even if the answering machine is Off, it will automatically pick up after 10 rings to enable
remote activation (See 7.3 “Remote Operation” )
7.1.3 Setting Number of Rings
The number of rings after which the answering machine will answer calls can be set from
2 – 9 and TS (Toll saver). The standard setting is 6 rings. In Toll saver mode, the machine
will answer after 6 rings if there are no new messages, and after 2 rings if there are new
messages. If there are no new messages and you call your machine to check your messages
remotely ( See 7.3 “Remote Operation” ), you can hang up after the 2nd ring. You do not
need to pay connection fees and you know that you do not have any new messages.
•
To check the actual number of rings, briefly press the ‘skip forward’
button. A voice will
playback the current number of rings.
•
Press
for 2 secs to set the number of ringing tones.
•
Press immediately
to change the current number of rings.
•
If you do not press any keys for 3 seconds, the machine will set the selected number of
rings.
7.1.4 Day and time setting
•
Press and hold the -key until the day is pronounced.
•
Press the
or
to change the day and press the -key to confirm and go to the hour
settings
•
Press the
or
to change the hours and press the -key to confirm and go to the
minutes settings
•
Press the
or
to change the minutes and press the -key to confirm
If the day and time are correctly entered, the unit will anounce the new setting.
If no outgoing message is recorded, a pre-recorded outgoing message will
be used.