Topcom OG-T700 - Manual (Page 26)

26 TOPCOM OGATECH OG-T700/Twin/Triple/Quattro
TOPCOM OGATECH OG-T700/Twin/Triple/Quattro
7.1.5 Memory Full
If the memory is full, the answering ON/OFF LED will flash on the base rapidly (0,5 sec.
ON/OFF). If the answering machine is turned On and a call comes in, the machine will
automatically play OGM 2 (answering machine function without recorded caller message).
When listening to the messages, the internal voice will announce that the memory is full and
then play back the messages.
Erase some or all the messages after listening to them.The memory is free again.
7.1.6 Programming the VIP Code
The VIP code is a 3-digit code used to operate the machine remotely ( See 7.3 “Remote
Operation” ). The VIP code is set to '123' by default. You can hear the current VIP code by
pressing the Ø-key shortly.
Press and hold the Ø-key for 3 seconds. The internal voice will ask you to enter the first digit
of the VIP code:
•
Press the or to change the first digit of the VIP code and press the Ø-key to
confirm.
• Repeat above until all 3 digits are set.
7.1.7 Recording and selecting a Outgoing message
•
Press and hold the -key until the voice ask you to select the outgoing message
• Press the to select OGM1 or to select OGM2. The selected message will be
played.
• After the selected OGM is played the internal voice will ask you to press and hold the
or to record a new one depending of which OGM you have selected. Press and hold
the corresponded key or during
recording.
• Stop recording by releasing the key. The new recorded message will be played.
7.2 Operation
If a call is received and the answering machine is turned ON, the answering machine will
automatically answer the call after the set number of rings.
If outgoing message 1 has been selected, the message will be played, a beep will be heard
and the caller can leave a message (max. 3 minutes).
If outgoing message 2 has been selected, after the beep, the line will automatically be
disconnected. The caller doesn’t have the possibility to leave a message.
You can press the -key shortly to hear the day and time.
If you do not press any keys for 20 seconds, the previous VIP code is saved
and the machine automatically exits the VIP setting mode.