TC electronic SDN BHD P2 - Manual (Page 20)

18
CLONING P2’S
Cloning P2’s
Creating the Clone Card
To easily clone multiple P2’s a PCMCIA card is
used.
• Load appropriate presets into Front Panel
Bank of the P2 you wish to clone.
• Insert a 512kb or 1Mb PCMCIA card in the
Card slot on the P2 front panel.
• Go to the System Card page.
• Decide whether you wish to exclude System
Preset 1 that holds overall Clock settings,
Analog Trim levels, Dither, Status Bit settings
and settings for GPI.
To exclude System Preset activate the
“Exclude System Preset” key.
• Press the CREATE CLONE CARD key on
the System/Card page.
• Please note following: ALL DATA
previously stored on the card will be
destroyed when formatting the card.
• If the card is write-protected no data
can be written on the card. The
protect/un-protect- switch is located
at the edge of the card.
Loading/Cloning P2 using the Clone Card.
Once the clone card has been created on the
P2 hooked up via the TC Icon PC Editor it is
time to transfer the card data to other P2’s in
your facility.
• Insert the PCMCIA card in the “target” P2.
• Press and hold the LOCK key while powering
up the P2.
• Press the LOCK key again. In this mode the
LOCK key operates as “CONFIRM”.
BYPASS can be used to abort operation.
• The target P2 is now loaded with the
information present on the card.