TC electronic SDN BHD P2 - Manual (Page 35)

33
APPENDIX LIMITER
Reset menu
& software load
To enter the following functions hold
WIZARD key while powering up the unit.
Once entered this menu navigation is as
follows:
• Press PRESET keys 4 and 8 to scroll in
menu.
• Press LOCK to confirm/enter
• Press BYPASS to cancel
“L” - Load
Indicates Load mode and is used when loading
application software.
Press LOCK (enter) to load the information
present in the inserted PCMCIA card.
“R” - Reset
Press LOCK (enter) to reset the unit.
When LOCK is pressed once the “R” in the
display will start to flash and the unit is ready to
be reset.
You can now abort/cancel the operation by
pressing the BYPASS key or press LOCK a
second time to actually reset the unit.
While resetting a “+” is displayed.
“A” - Boot software version
Press LOCK (enter) to see current loaded boot
software version.
For service-purposes only.
“V” - Operating software number
Press LOCK (enter) to see current loaded P2
software version.
“N” - Serial Number
Press LOCK (enter)to see serial number for
this unit.
“S” - Start
Reboots the P2 for normal use.
When rebooted after a Reset procedure has
taken place all Front Presets are reconfigured.
The reconfiguration process takes approx. 15
seconds during which the eight PRESET key
LEDs will flash. Be patient.
peaks from reaching the Output, and time-
constants adapt to the Input signal.
Fader A & Fader B
Parameter range: Off to 0dB
Fader function on the Output. When Dual Mono
configuration is selected, individual Output
faders are available.