TC electronic SDN BHD P2 - Manual (Page 8)

6
FRONT PANEL OVERVIEW
POWER On/Off
Switches power On/Off.
To completely disconnect from
mains the Rear panel POWER
switch must be used.
PCMCIA slot
For software updates and
preset backups.
ERROR LED
Indicates various error states.
48/44.1/32 kHz LEDs
Indicates current Sample Rate.
ANALOG IN/DIGITAL IN
Indicates currently selected
Input type.
DUAL MONO LED
Indicates that the P2 is
operating in Dual mono mode.
EDITED LED
Indicates that the currently
recalled preset has been
edited but not stored.
This LED will also be lit
when the Wizard has
been activated.
GAIN meter
Indicates the max gain applied
on either channels. The
indication is “wideband” type.
OPTIMIZE meters
Indicates the gain optimization
on each of the 5 bands.
LIMIT meter
Indicates the max limitation
performed on either channels.
INPUT/OUTPUT meters
• The Input meters indicate
the level of the Input signal
after the In Gain control.
(set via the TC Icon control
interface).
• The Output meters indicate
the current Output level.
• Threshold value for meter
color change:
For both Input/Output
meters: Below -20dB the
meter LEDs are green.
From -20dB to 0dB LED
color can be green or
yellow.
The value for this color
change is set via the TC
Icon Editor on the System
Front page.