TC electronic SDN BHD P2 - Manual (Page 23)

21
If GPI Preset mode is selected and no
connections are made to the GPI Input
the P2 will always recall preset 1 at
power up.
Delay
Frame compensation Delay. Actual Delay time
can be tapped using a connected momentary
switch.
Calibrate
Use this function to calibrate P2 to a connected
GPI controller. E.g. TC Master Fader (not
supplied).
To Calibrate:
• Connect GPI Controller to GPI Input and
press CALIBRATE.
• Set GPI controller to Minimum position and
press “Set Lo Threshold”.
• Set GPI controller to Max position and press
“Set Hi Threshold”.
• Press OK and calibration is done.
GPI Current voltage:
Indicates the current voltage on the GPI Input.
With no GPI controller connected the voltage is
1000 mV. Therefore it is worth noticing the max
indicated value on e.g. Master Fader is a lower
value in voltage compared to the min value.
SYSTEM - FRONT PAGE
Front Panel Configuration
On this page various preferences for the
Front panel controls are set.
Wizard Mode
This parameter sets up the functionality of the
front panel WIZARD key. The Wizard function
examines part of the program material and
automatically finds optimal compression
settings based on the evaluation and the
selected mode.
Via the TC Icon Editor the Administrator can
both enable/disable the WIZARD function and
also select between the three modes that
determines the intensity of the compression.
Modes
Light
Mild compression is applied for preserved yet
controlled dynamics. Only 1 to 2dB.
Normal
Medium compression is applied. 3-4 dB
Heavy
A harder compression for maximal control of
dynamics. The compression is typically up to 6-
8dB. Consider whether the processing material
will suffer from this type of compression.
Lock Mode
This parameter sets up the functionality of the
front panel LOCK key. Thereby the editing
options for the everyday user can be limited to
different degrees.
Press the round LOCK key to activate the Lock
function.