TRENDnet 10/100 Mbps Ethernet Card PF-16 PCMCIA - Manual (Page 27)

• • ! • • • • • • • —Driver installation for DOS environments

! 
23
The Install program will automatically add a line to your
CONFIG.SYS file using the following syntax and format:
DEVICE=[path_name]CARDGO.EXE [/ IRQ =xx] [/ IO =xxx][/MEM=xxxx][/?]
where
[/IRQ=xx] Specifies the hardware interrupt of your card. Default
value is 5.
Valid IRQs are 3, 4, 5, ,9, 10, and 11.
[/IO=xxx] Specifies the I/O address. Default value is 300.
Valid port addresses are 300, 320, 340, 360, 240, and
280.
[/MEM=xxxx] Specifies the memory address. Default value is
D400H.
Valid memory addresses are D000H, D400H, D800H,
and DC00H.
[/?] Displays all possible command syntax.
You can also run CARDGO.EXE by typing “CARDGO” at the
D O S p r o m p t o r b y i n c l u d i n g i t a s a l i n e i n y o u r
AUTOEXEC.BAT file.
After you executed CARDGO.EXE, you will see a display similar
to the following indicating that the installation was successful:
Socket : 0
IRQ Number : 05
I/O PORT Base : 300H
MEM Base : D000H
The list of error messages the client driver may display and the
correction methods suggested are given in Appendix B.