TRENDnet 10/100 Mbps Ethernet Card PF-16 PCMCIA - Manual (Page 37)

33
Appendix B Appendix B Appendix B Appendix B
Enabler program error messages
CARDGO.EXE
Here is the list of error messages the CARDGO.EXE may display.
Error Message Solution
[Error 1] “The PCMCIA controller is
not present or recognized” There is no PCMCIA con-
troller on your computer.
Install a PCMCIA controller
from another computer.
[Error 2] “There is no card in the
PCMCIA slot. Insert the
card.” Ensure that the PC card is
correctly inserted into the
PCMCIA slot.
[Error 3] “The card in PCMCIA slot is
not PCMCIA 10/100 Mbps
Ethernet Card. Insert it” Ensure that the PC Card in
the notebook’s PCMCIA
slot is the Ethernet Card
and that it is correctly in-
serted.
[Error 4] “The I/O ports do not re-
spond. Change to another
one” Change to another I/O port
using /IO=xxx. Refer to
“Manual Installation” in
Chapter 4.
[Error 5] “The I/O ports specified are
invalid. Change to another
one” Valid I/O addresses are
240, 280, 300, 320, 340,
and 360.
[Error 6] “The IRQ specified is invalid.
Change to another one” Valid IRQ values are 3, 4,
5, 9, 10, and 11.