TRENDnet 10/100 Mbps Ethernet Card PF-16 PCMCIA - Manual (Page 9)

• • ! • • • • • • • —Hardware installation

! 
5
Ethernet Card RJ-45 connector LEDs
The following illustration shows the Ethernet Card RJ-45 con-
nector LEDs:
Fast
Ethernet ACT
1 0 0 M
LNK
AC T 10 0 M LNK
Figure 2-4: RJ-45 connector LEDs
The following table describes the meaning of the LEDs:
LED MEANING
ACT Indicates transmit or receive activity. It is normally off.
When there is packet transmit or receive activity, this LED
is on.
100M Indicates the connection speed. When off, the connection
speed is 10 Mbps. When on, the connection speed is 100
Mbps.
LNK Indicates whether the link is active or not. When lit, indi-
cates that the link is active. When off, indicates that the link
is inactive.
Disconnecting the Ethernet Card
The Ethernet Card RJ-45 connector is designed to lock in place
when connected to the Ethernet Card. The following illustration
shows the location of the clips: