TANDBERG Utility - Manual (Page 12)

TANDBERG COMPASS MXP / UTILITY MXP
4
far end. The power output of the lamp can be varied upon installation (or by service personnel
thereafter), and can be adjusted from zero to full power.
Remote Control
The remote control is only delivered with the TANDBERG Utility MXP.
The remote control is located inside the locked cabinet on the Utility MXP, and is intended for
system setup when using ISDN. The reception of the remote control signal is limited to a small
hole directly under the speaker mesh on the Utility MXP.
The remote control is used to control all functions of the system. The remote control uses 4 AAA
batteries. The system will tell you when batteries are running low. Change the batteries at the
back of the remote control.
The reach of the remote control signal is around 20 meters. For users sitting in an open plan
office, this can cause problems. Use the little, white switch placed under the batteries to change
the reach of the signal from 20 meters to 2 meters. This will prevent you from unintentionally
controlling another video system, when you control your own system.