TANDBERG Utility - Manual (Page 187)

7 Glossary
179
SVGA: Super VGA. (800x600)
SXGA: Super extended Graphics Array (1280x1024)
System information: Lists system numbers, line status, software version and other useful
information.
System name: Identifies a videoconferencing system
T
T1: Network type, 24 channels. Default for NTSC versions.
T1 Line Coding: Indicates how the signals on the line should be coded. If parts of the systems
use restricted coding, this should be selected.
Take chair: Request chairmanship of the conference. If no one else is chairman, the request is
granted.
TCS-4: Used to address different systems on a LAN when dialing in via a gateway.
Terminal Names: Lists the site numbers or name (if supported) of other sites connected in the
conference.
Terminate meeting: The chairman can terminate the conference, i.e. all participants are
disconnected.
TMS: TANDBERG Management Suite
Touch Tones: To dial extension numbers etc. during a call, use touch tones in order to get tones
instead of preset on the number keys.
Tracker: The tracker is a small infrared remote control device made to steer the camera to any
desired location within the room.
TSC-1: TCS-1 is used for H243 password on H320 MCU's
V
VCR: Video Cassette Recorder
VGA: Video Graphics Array. (640 x 480)
VGA Out Quality: Changes the resolution of the VGA signal available in the VGA Out connector
at the rear of the codec.
View administrator settings: Displays all the system settings in a read only format.
View site: View any participant in the conference other than the participant currently On Air. Can
be used by all conference participants.
VNC: Virtual Network Computing.
Voice Switched: The active site will be displayed in full screen during a MultiSite conference.
W
WAVE II Camera: Wide Angle View Camera - delivers the widest angle of view in the industry.
Welcome menu: The welcome menu displays the main menu when you are outside a call.