TANDBERG Utility - Manual (Page 18)

TANDBERG COMPASS MXP / UTILITY MXP
10
2.2 Connecting Cables
1. Power cable

Connect the power cable
from the wallplate to the
power supply.

Note: The connection of
main electrical supply to
the wallplate is described
in the Installation Sheet.
2. ISDN cables

Connect the ISDN cables
to the ISDN connectors
on the system.

Connect the ISDN cables
to the ISDN sockets (S/T-
interface) provided by the
service provider. Your
main number will be the
number associated with
the socket to which ISDN
cable number 1 is
connected.
North America: The system does
not have a built-in network
terminator. If the wall socket
provides an ISDN U-interface, an
NT1 between the system and the
ISDN line is needed, see
Appendix 8 for details.
Note! Write down the
numbers associated with
each of the ISDN lines.
They are needed for
configuring the system
Figure 2-1. Connectors.
3. LAN cable
To use the system on LAN,
connect a LAN cable from the
Ethernet' connector on the system
to the LAN.