TANDBERG 6000 MXP - Manual (Page 23)

Installation
13
2.2 Connecting Cables
All cables needed in standard configuration are already connected to the codec. Connect these
cables to their respective parts of the system as shown in the figure below.
1. Power cables
Connect the system power cable and monitor power cable to an electrical distribution socket.
2. Monitor cables
Connect the S-video cable to the input on your monitor as shown in the figure above.. For
Scart-monitors, use the Scart-adapter. Only a video connection cable is required, as the Digital
Natural Audio Module will provide the audio output.
3. Microphone cables
Connect the microphone cable to the microphones.
4. Camera cable