Toshiba RAV-SM1101BT-E - Manual (Page 115)

113
Air-outlet
cabinet
Bell-mouth
Bell-mouth
Air-outlet cabinet
Minus screwdriver
Square holes (3 positions)
Bell-mouth
Hooks (3 positions)
Hanging hook Air-outlet cabinet
Fan guard
Screws
(2 pcs)
Remove
No.
Š
Part name
Fan guard
Procedure
1. Detachment
1) Perform the works in 1 of

and in 1 of
‚
.
REQUIREMENT
To prevent damage on the products, treat
component on a corrugated paper, cloth,
etc.
2) Remove the air-outlet cabinet, and then
put down it directing the fan guard side
downward.
3) Take off screws fixing the bell-mouth.
(ST1T Ш4 Ч 10, 2 pcs)
4) Remove the bell-mouth.
5) Take off screws fixing the fan guard.
(ST1T Ш4 Ч 10, 2 pcs)
6) Remove hanging hook of the fan guard by
pushing with a minus screwdriver.
2. Attachment
1) Insert the extrusion at the upper side of
the fan guard into the square hole of the
air-outlet cabinet, and then insert the
hanging hook. Fix the hanging hooks
(5 positions) by pushing with hands.
REQUIREMENT
Check that all the hanging hooks are fixed
to the specified positions.
2) After attachment, fix it with screws.
(ST1T Ш4 Ч 10, 2 pcs)
3) Mount the bell-mouth by hanging hooks
(3 positions) at upper side of the bell-
mouth to the square holes of the air-outlet
cabinet.
4) After attachment, fix it with screws.
(ST1T Ш4 Ч 10, 2 pcs)
* Caution in assembling bell-mouth
• The size (color) of the bell-mouth at
upper side differs from that at lower side.
(Only for RAV-SM1100AT-4C)
<In case of RAV-SM1100AT-E>
Upper side: Black
Lower side: Gray
<In case of RAV-SM1400AT-E>
Upper side: Black
Lower side: Black
Remarks