Maintenance, Service technician maintenance – Trane Voyager 1 Rooftop Unit TSD User Manual

Page 61

Advertising
background image

Maintenance

61

RT-SVX20A-E4

Note: Do not attempt to clean
disposable filters. Permanent filters
can be cleaned by washing with a
mild detergent and water. Ensure
that the filters are thoroughly dry
before reinstalling them in the unit
(or duct system).

Note: Replace permanent filters
annually if washing fails to clean
them, or they show signs of
deterioration. Be sure to use the
same type and size as were
originally installed.

Condenser coil

Unfiltered air circulates through the
unit's condenser coil and can cause
the coil's surface to become
clogged with dust, dirt, etc. To clean
the coil, brush the coil surface in the
direction of the fins with a soft
bristled brush.

Keep all vegetation away from the
condenser coil area.

Hot water coil (option)

Stop the unit. Do not disconnect the
main supply to the unit. This will
permit the anti-frost protection to
continue to operate, and avoid
water to freeze-up in the coil.

Service technician
maintenance

Before the cooling season, your
service technician may examine the
following areas of your unit:
• Filters, for cleaning or

replacement

• Motors and drives system

components

• Economizer

gaskets,

for

replacement if necessary

• Condenser coils, for cleaning
• Safety controls, for mechanical

cleaning

• Electrical components and

wiring, for replacement and
tightening of connections as
necessary

• Condensate drain, for cleaning
• Unit duct connections, to ensure

they are physically sound and
sealed to the unit casing

• Unit mounting support, to

ensure that it is sound

• The unit, to ensure there is no

obvious deterioration

Before the heating season, your
service technician may examine the
following areas of your unit:
• The unit, to ensure that the

condenser coil can receive the
required airflow (that the
condenser fan grille is not
obstructed)

• The control panel wiring, to

verify that all electrical
connections are tight, and that
wire insulation is intact

• Clean burner area, verify the gas

heat system operates properly.

Advertising
This manual is related to the following products: