True Manufacturing Company TDC-47 - Manual (Page 11)

............ www.truemfg.com ............
True Food Service Equipment, Inc.
9 9
A. Before your new unit is connected to a power supply,
check the incoming voltage with a voltmeter. If
anything less than 100% of the rated voltage for
operation is noted, correct immediately.
B. All units are equipped with a service cord, and must
be powered at proper operating voltage at all times.
Refer to cabinet data plate for this voltage.
TRUE requires that a sole circuit be dedicated
for the unit. Failure to do so voids warranty.
WARNING
Compressor warranties are void if compressor burns out due
to low voltage.
WARNING
Power supply cord ground should not be removed!
WARNING
Do not use electrical appliances inside the food storage
compartments of the appliances unless they are of the
type recommended by the manufacturer.
NOTE
To reference wiring diagram - Remove lower rear grill.
Wiring diagram is positioned on the inside cabinet wall.
ELECTRICAL INSTRUCTIONS
INSTALLATION / OPERATION INSTRUCTIONS
A. The compressor is ready to operate. Plug in the unit.
B. The temperature control is set at the No. 4 position
from the factory. Allow unit to function several
hours, completely cooling cabinet before changing
the control setting.
C. Excessive tampering with the control could lead to
service difficulties. Should it ever become necessary
to replace temperature control, be sure it is ordered
from your TRUE dealer or recommended service agent.
NOTE
If the unit is disconnected or shut off, wait five minutes
before starting again.
RECOMMENDATION
Before loading product we recommend you run your TRUE
unit empty for two to three days. This allows you to be sure
electrical wiring and installation are correct and no shipping
damage has occurred. Remember, our factory warranty does
not cover product loss!
REPLACEMENT PARTS
TRUE maintains a record of the cabinet serial number for
your unit. If at any time during the life of your display case, a
part is needed, you may obtain this part by furnishing the
model number and serial number to the company from
whom you purchased the cabinet. Call Toll-Free: (800)-424-
TRUE (Direct to Parts Department). (800)-325-6152 (U.S.A. &
Canada only) or call:
(636)-240-2400.
STARTUP
Serial Number
REMOTE UNITS (This section applies to remotes only!)
• Remote cabinets must be ordered as remote. We do not
recommend converting from a standard self contained to
remote system.
• All remote cabinets must be hard wired.
• No castors available.
• All remote cabinets come standard using 404A refrigerant.
• All remote units come standard with expansion valve,
liquid line solenoid, heated condensate pan, and defrost
timer when applicable.
• Contact TRUE Technical Service for BTU requirements.
• No wiring necessary between cabinet and condensing unit.
• All remote condensing units purchased from TRUE are
208/230 volts single phase.
If you have any questions regarding this section, please call
TRUE at 1-(800)-325-6152.