True Manufacturing Company TDC-47 - Manual (Page 9)

............ www.truemfg.com ............
True Food Service Equipment, Inc.
7 7
OPTIONAL DIPWELL FOR TDC MODELS
(Installing Dipwell):
TRUE
Dipping Cabinets come standard with pre-installed riv-nut holes to
attach an optional dipwell. There are multiple riv-nut holes for dipwell
locations on the cabinet. Locate which area you want the dipwell installed
then proceed with the directions below. (See image 1).
A . Remove the dipwell backplate from one of two boxes that contain
the dipper well assembly.
B . Two Phillips pan head machine screws are provided in the kit to
mount the backplate to the cabinet with the Inlet Tube Clip and
Inlet Tube. (See image 2 and illustration 1).
C . After attaching the dipwell bowl to the backplate connect
the drain tube to the bowl and run it to a floor drain.
D . Assemble the Plastic Tube to the Barrel Valve and then
onto the Inlet Tube. (See illustration 1).
E . Have a plumber tap the Saddle Valve Assembly into
the copper water line.
INSTALLATION / OPERATION INSTRUCTIONS
Riv-nut locations
Dipwell Backplate installation
Dipwell bowl installation
10" Deep Drawn
"Dipwell"
Backplate
1/4"-20nc x 5/8"
S.S.T. Pan Head
Machine Screw
Inlet
Tube
Inlet
Tube
Clip
Leather Gasket
Overflow
Tube
Barrel Valve
Male Connector
Assembly
Ferrule
Saddle Valve Assembly
Riv-Nut
Locations
Riv-Nut
Locations
Illustration 1
Leather Gasket Coupling Nut
Tail
Piece
Barrel
Valve
Ferrule
10" Deep Drawn
"Dipwell"
Overflow Tube
Inlet Tube
Inlet Tube Clip
S.S.T. Pan Head
Machine Screws
Backplate
Male Connector
Assembly
Male
Connector
Assemblies
1/4” Plastic Tubing
(leading toward water source
[saddle valve assembly])
Coupling Nut
Tail Piece
( 1” Connection
will be needed
for the drain).
1
2
3