True Manufacturing Company TDC-47 - Manual (Page 8)

............ www.truemfg.com ............
True Food Service Equipment, Inc.
6 6
INSTALLATION / OPERATION INSTRUCTIONS
INSTALLATION OF OPTIONAL LEGS
AND CASTORS
Removing Kickplate:
Before installing optional legs or castors the kickplate at the
bottom of the unit will need to be removed. To remove kickplate
first remove any loose items from inside the unit (shelving,
baskets, etc). Then remove the top plastic lid which you gain
access to the inside of the unit. Lay the unit on it's side. Make
sure the unit is on soft packing material so not to scratch the
cabinet. Then backout 1/4" hex head screws all around the
base of the unit. (See illustration 1 and image 1). After the
kickplate has been removed reinstall all of the hex head screws
back into the base of the unit. (See image 2). Castors and legs
are to be installed in the corners of the base of the unit.
Unit Leveling With Castors:
Four leveling shims have been provided for leveling on uneven
floors when using optional castors. Shims must be positioned
between the base of the unit and bearing race. TRUE
recommends a four shim limit to any single castor.
A. Turn the bearing race counter-clockwise until the cabinet is
level. Level front to back and side to side. (diagonally)
B. Install the desired number of shims, making sure the slot
of the shim is in contact with the threaded stem of the
castor.
C. If more than one shim is used, turn the slot at a 90° angle
so they are not in line.
D. Turn the bearing race clockwise to tighten and secure the
castor by tightening the anchoring bolt with a 3/4-inch
open-end wrench, socket, or the tool provided.
CAUTION
To avoid damage to lower rail assembly, slowly raise unit to
upright position after installing castors.
Unit Leveling With Legs:
Turn the legs clockwise to tighten in each corner of the
cabinet base. (See image 4). After legs are secure level the unit
by backing out the end the leg shown in image 5. Turn the
end of the leg until the cabinet is level. Level front to back
and side to side (diagonally).
NOTE
Please be sure to follow the directions in Image 2
for correct cabinet operation.
Optional Castors and Legs
Standard Kickplate
Illustration 1.
Removing kickplate Reinstalling screws from kickplate
Installing castors Installing legs Leveling legs
1 2
3 4 5