Tyco Electronics MM23772 - Manual (Page 101)

MM23772, Rev. B
101
Green: Receiving
Red: Unencrypted transmission
Orange: Encrypted transmission
10.4 STATUS MESSAGES
During radio operation, various radio Status Messages can be displayed. The messages are described
below.
MESSAGE NAME DESCRIPTION
TALKARND Talkaround Indicates the radio is operating on conventional channels in talkaround
mode (no repeater).
LOW BATT Low
Battery Battery voltage has dropped to the point to where the radio is no longer
able to transmit. The radio will still receive calls until the battery is
discharged beyond the point of operation at which time the radio will
automatically shutdown.
VOL=31 Volume
Level Indicates the current volume level. The volume level display ranges from
OFF (silent) to 31 (loudest).
10.4.1 Error Messages
If either of the Error Messages shown below is displayed, the radio is programmed incorrectly or needs
servicing.
DSP ERR
ERR=XXXX
(PowerUp
only)
or DIG V x
ERR x
Where: xxxx is the error code and DSP ERR or DIG V ERR is the message.
10.5 ALERT TONES
The P7200 radio provides audible Alert Tones or “beeps” to indicate the various operating conditions (see
Table 10-2).
Table 10-2: Alert Tones
NAME TONE DESCRIPTION
Call Originate one short mid-pitched OK to talk after pressing the push-to-talk
button
Carrier Control
Timer five high-pitched/one long low-
pitched PTT depressed for maximum length of time
Low Battery one low-pitched/one short mid-
pitched Low battery
TX Low Battery
Alert one low-pitched After PTT - battery too low to transmit