Tyco Electronics MM23772 - Manual (Page 57)

MM23772, Rev. B
57
METHOD 2: (System and Scan model radios only) From keypad: If group selection is
programmed as the primary function of  and  select a group by pressing
 or  to scroll through the group list. The display registers the new group
name on line two.
METHOD 3:
(System model radios only) Direct Access: Press  to enter the group select
mode. Press the numeric key mapped to the desired group. Press  . The radio
will move to the selected group.
METHOD 4:
(Select model radios only) If programmed for groups, press the  button to
change groups. The display registers the new group name on line two. If
programmed for channels, press the  button to change the channel. The
display registers the new channel.
8.11 MODIFY SCAN LIST
8.11.1 System Model
1. Press  to toggle scan OFF and verify is not displayed.
2. Select group or channel.
3. Press  once to remove group or channel from list.
4. Press  once to add as a normal group or channel.
5. Press  twice to add as a Priority 2 group.
6. Press  three times to add as a Priority 1 group.
7. Press  to re-start scanning.
8.11.2 Scan Model
1. Press  to toggle scan OFF and verify is not displayed.
2. Select group or channel.
3. Press  once to remove group or channel from the list.
4. Press  once to add as a normal group or channel.
5. Press

twice to add as a Priority 2 group.
6. Press  three times to add as a Priority 1 group.
7. Press

to re-start scanning.