Tyco Electronics MM23772 - Manual (Page 103)

MM23772, Rev. B
103
10.8 GROUP/CHANNEL SELECTION
Several methods can be used to select a new group or channel.
METHOD 1: From the control knob: If group selection is programmed to the SYSTEM/GROUP/
CHANNEL knob, select a group by turning the SYSTEM/GROUP/CHANNEL knob to
the desired group number position. The display registers the new group name on line
two. If the knob is moved to a position greater than the number of programmed groups,
the highest programmed group will remain selected. The  button can be programmed
to provide access to a “2
nd
bank” of 16 group number positions (17-32)
METHOD 2: (System and Scan model radios only) From keypad: If group selection is programmed
as the primary function of  and  select a group by pressing  or  to scroll
through the group list. The display registers the new group name on line two.
METHOD 3: (System model radios only) Direct Access: Press  to enter the group select mode.
Press the numeric key mapped to the desired group. Press  . The radio will move to
the selected group.
METHOD 4:
(Select model radios only) If programmed for groups, press the  button to change
groups. The display registers the new group name on line two. If programmed for
channels, press the  button to change the channel. The display registers the new
channel.
10.9 MODIFY SCAN LIST
10.9.1 System Model
1. Press  to toggle scan OFF and verify is not displayed.
2. Select group or channel.
3. Press  once to remove group or channel from list.
4. Press  once to add as a normal group or channel.
5. Press  twice to add as a Priority 2 group.
6. Press  three times to add as a Priority 1 group.
7. Press  to re-start scanning.
10.9.2 Scan Model
1. Press  to toggle scan OFF and verify is not displayed.
2. Select group or channel.
3. Press  once to remove group or channel from the list.
4. Press  once to add as a normal group or channel.
5. Press

twice to add as a Priority 2 group.
6. Press  three times to add as a Priority 1 group.