Tut Systems XL-12000S - Manual (Page 21)

XL-12000S
MANAGED, HIGH-SPEED NETWORK MODEM USER GUIDE
7.0 CONFIGURE THE MODEM TUT SYSTEMS 13
1. Go to the Call menu and select connect. You will see the
Serial Session/Version ID screen (Figure 7.1).
m. To verify that you have correctly configured your PC’s
serial port, press the <Enter> key and the XL-12000S
Login Display screen (Figure 7.8) should appear.
n. If your terminal remains blank, press <Ctrl-X> and enter
again. If it is still blank, make sure you have entered the
correct settings in step seven above. Verify that you are
using the correct cable and have a good connection. If you
are still unable to view the Login Display screen, refer to
section 10.0, “Troubleshooting”.
Figure 7.1 Serial Session/Version ID Screen
2. When Login is displayed press <Enter>. Ignore the request for
a password. (Screen shots for this process are contained in sec-
tion 7.8 and Appendix B)
3. In the Main Menu, select “C”.
4. In modem configuration change “Slave” to “Master” by typing
“M” in the Master/Slave field to designate this modem as the
Master. Press <Enter> and this modem is now the Master.