Tut Systems XL-12000S - Manual (Page 36)

XL-12000S
MANAGED, HIGH-SPEED NETWORK MODEM USER GUIDE
28 TUT SYSTEMS 7.0 CONFIGURE THE MODEM
7.2.3 Procedures for Initial Configuration
A serial console port session allows you to assign an IP address,
mask, and default gateway to each new modem if required. Once
installed and configured, you can open a Telnet session from a PC
attached to a network that is connected to one of the XL-12000S
LAN ports to configure further changes. Only one console session,
either console port or Telnet based, can be open at one time.
Availability is first come, first served. SNMP requests may occur
at the same time as a Telnet session.
This section begins with setting up your first console session, shows
you how to configure one unit as Master and the other as Slave and
ends with configuring each modem as a router or as a bridge. This
section also shows how to open a Telnet session and how to set
a password.
7.2.3.1 HyperTerminal
This section assumes you can perform terminal emulation such as
HyperTerminal (described here) or another emulation package.
Consult your operating system user guide for more information.
Configuring the Windows terminal emulation program
HyperTerminal:
1. From the Windows 95/Windows 98 screen select “Start.”
2. Select “Programs” (or Open file Hypertrm.exe).
3. Select “Accessories.”
4. Select “HyperTerminal.” Double click on the HyperTerminal
icon.
5. On the Connection Description icon, assign a name (i.e.,
Modem 1) to the icon for future purposes. Press “OK”.
(When Phone Number tab appears, press “Cancel”.)
6. Click File / Properties: Press the <Configure> button on the
Properties screen.
Back to Table of Contents