Figure 7.11 modem configuration screen, Table 7.3, Back to table of contents – Tut Systems XL-12000S User Manual
Page 44
XL-12000S
MANAGED, HIGH-SPEED NETWORK MODEM USER GUIDE
36
TUT SYSTEMS
7.0 CONFIGURE THE MODEM
Figure 7.11 Modem Configuration Screen
1.
The cursor is now blinking at entry for Master/Slave. The
default setting is “S” for Slave. Designate only one modem in
each pair to be the Master by entering “M” in this field.
2.
Tab to the Name field (optional). Refer to the table for name
parameters (see Table 7.3). Enter the name of the modem.
This field holds the same value as the Modem Name field in
the Modem Management screen and therefore may already
have an entry.
3.
Tab to the Routing/Bridging field. Enter numeric keys 1-4 based
on the network planning previously done (see section 7.2.1).
4.
Tab to the LAN IP Address field. Confirm that the entry is the
value you entered previously in section 7.2.3.4. (Necessary for
remote management or if Bridge/Routing options 2 or 3 are
selected.)
5.
Tab to the DSL IP address field. If option 1 or 4 was entered in
the Routing/Bridging field no entry is required. If option 2 or 3
is entered, enter the DSL IP address previously derived from
your network planning session.
6.
Tab to the Subnet Mask field for the LAN IP address.
Confirm the entry is the one entered previously in the Modem
Management screen in section 7.2.3.4.