Tunturi C40 - Manual (Page 5)

G B
5
O W N E R ' S M A N U A L
•
C 4 0
Push the left footrest support forward so that you
can push the adjustment tube in the front of the
foot rest support inside the arm tube. Lock the
adjustment tube with the locking screw. Repeat the
procedure with the right footrest support.
N OTE ! The European model allows selecting
adjustment (see Adjusting the footrest supports).
METER AND HANDLEBAR
Attach the handle bar into the front frame
tube.Withdraw the plastic covers on the screws and
thread the hand pulse cords through the opening in
the front frame tube. Pull the screws tightly so that the
handlebar does not move during the training. Push the
plastic covers onto the screws.
Unscrew the two screws in the bottom of the console.
Attach the cord from the front tube and the pulse cords
to the console outlets. Push the console onto the end of
the front tube and fasten the console with the fastening
screws. Be careful not to damage the cords!
TRANSFORMER
Before connecting the equipment to a power source,
make sure that local voltage matches that indicated on
the type plate: the equipment operates at either 230 V
or 115 V (North American version). Plug the socket end
of the transformer cord into the connector, just above
the rear support in the center of the frame, and the
other end into the wall socket.
N OTE ! The equipment must be connected to a
grounded wall socket. Do not use extension wires
when connecting the equipment to the power source.
Make sure the power cord does not run underneath the
equipment.
DA N G E R : Always switch off the power and unplug
this appliance from the electrical outlet immediately
after using.
WA R N I N G : To reduce the risk of burns, fire, electric
shock, or injury to persons:
Tunturi_C40 5 7.1.2005, 15:13:05