Charging the pa500 – Unitech ENTERPRISE PA500 User Manual
Page 12
6
Copyright 2007 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
Charging the PA500
For initial use, you need to charge your device for about 16 hours. After that, you can charge it
everyday to recharge the battery to full capacity. You can charge your device using the USB charging
cable or the docking station.
CAUTION!
Operating the PA500 for the first time without the AC adapter, and
without fully charging the backup battery may result in loss of data
stored in RAM memory.
NOTE:
Data you enter may not be properly stored until the internal backup battery has been
adequately charged.
To charge the device using the USB charging cable:
1.
Install the clip plug to the AC adapter, if necessary. Slide the replaceable clip plug into the AC
adapter until it locks into place with an audible click.
2.
Press and hold the connector button on the USB charging cable and connect it to the PA500
(1).
3.
Plug the AC adapter cable into the power jack on the USB charging cable (2).
4.
Connect the AC adapter into an electrical outlet (3).