Uniden Data 2000 Wireless CDPD PC Card - Manual (Page 23)

▲ ▲ Uniden Data 2000 Wireless CDPD PC Card
Uniden Data 2000 Installation and Operation Manual 2-15
2.4.5 Setting Up Dial-Up Networking for PPP
Dial-Up Networking for PPP is automatically created when installing
UD Host Application (Section 2.2) If the computer has installed
multiple modems, make sure to click on Connect Using and select
Uniden Data 2000 PC Card.
To setup Dial-Up Networking for PPP, take the following steps:
1. Double-click on the My Computer icon.
2. Open the Dial-Up Networking folder.
Verify that a file PC Card PPP was created. (It should be generated
during Host Application Installation). If the file is not found, continue
with the following procedures.
3. Double-click on the Make New Connection icon.
4. When you are instructed to select a modem, click on Uniden
Data 2000 PC Card. Change the name of the connection
from My Connection to PC Card PPP, then click Next.
5. Enter the single digit: 0 in the Telephone Number box.
Deselect Use Country code and area code.
6. Right click on PC Card PPP to activate the Pccard screen.
Select Properties.