Uniden Data 2000 Wireless CDPD PC Card - Manual (Page 85)

D.1.2 Service Provider’s Default Table (SPDT)
The Service Provider’s Default Table (SPDT) contains configuration
information restricted by your local service provider’s CDPD network.
Each of the parameters in the SPDT can be read by any user, but
modified only by an authorized user.
To set the configuration parameters for the SPDT, take the
following steps:
1. Contact your service provider directly for specific
configuration values restricted by their CDPD network.
2. Call Uniden customer service at 1-888-6-UNIDEN to receive
the SPDT password. Once you receive the SPDT password
from Uniden, you are solely responsible for it’s protection and
distribution. Uniden is not liable for the protection and
distribution of the SPDT password once it has been passed on
to the user. It is strongly recommended that you keep the
SPDT password in a secure location.
Take the following steps to modify the SPDT:
1. Login using the SPDT password.
2. Change the values in the CAT using appropriate
AT commands.
3. Save changes to the SPDT by typing in the command AT
SAVECFG SPDT.
4. Logout.
For login and logout procedures, see the section titled E.4 Login and
Logout Procedures, in this chapter.
D.1.3 User’s Default Table (UDT)
The User’s Default Table (UDT) contains configuration information
defined by the user. To change the UDT parameters, make your
configuration changes to the CAT, then save the information from the
CAT to the UDT by typing in the command AT SAVECFG UDT.
▲ ▲ Uniden Data 2000 Wireless CDPD PC Card
Uniden Data 2000 Installation and Operation Manual D-3