Uniden Data 2000 Wireless CDPD PC Card - Manual (Page 25)

▲ ▲ Uniden Data 2000 Wireless CDPD PC Card
Uniden Data 2000 Installation and Operation Manual 2-17
13. From the TCP/IP Settings box, if you have been given the
address of a Domain Name Server (DNS), select Specify name
server addresses. Enter the address as your Primary DNS.
Note: A DNS is needed to access sites by name, i.e.
www.uniden.com.
14. Deselect Use IP header compression.
15. Select Use default gateway on remote network.
16. Click on OK 3 times to exit the properties program.
2.4.6 Adding TCP/IP Protocol Support
To add TCP/IP protocol support, take the following steps:
1. Double-click on the Network icon in the Control Panel.
2. Click Add.
3. Click Protocol, then click Add.
4. From the Manufacturers box, select Microsoft.
5. From the Network Protocols box, select TCP/IP.
6. Click OK twice. Now Windows 95 will install the TCP/IP
stack and any other protocol it requires.
7. After the protocols are installed, click OK.
8. Restart Windows 95.
2.4.7 Connecting to the CDPD Network
To connect to the CDPD Network, take the following steps:
1. Double-click the new icon you created in the previous section.
2. A window should appear, displaying the progress of your
connection. Within a few seconds, the connection display
should show that a connection has been established. Once
this has occurred, you may minimize the window and
proceed with Windows 95 Internet programs such as web
browsers and e-mail.