VTech i 5836 - Manual (Page 10)

8
Setup
Follow the steps below:
Installation of Battery Pack in Handset
Getting
Started
i 5886 manualNov11.p65 11/12/2003, 9:50 AM 8
R e m o v e t h e b a t t e r y c o m p a r t -
m e n t c o v e r b y pressing on the
indent and sliding downward.
Place the new battery pack in the
Handset with the metal contacts
aligned with the charge contacts
in the battery compartment.
Replace the battery compartment
cover by sliding it upward.
If the new battery pack is not
already charged, place the Handset in
i t s C h a r g e r , a n d a l l o w i t t o
charge for 12 hours. After initial
charge, a maintenance charge of
8 hours should be sufficient.
2.
1.
3.
4.
The original Handset that is shipped with your i 5836 system will
be automatically registered to the Base. This Handset is HANDSET 1.
• The low battery message is displayed:
•
•
As you register additional Handsets to the system, they will be assigned
extension numbers in the following order: HANDSET 2, HANDSET 3, etc.
Whenever a charged Handset battery pack is installed, the Handset will
automatically begin Searching for Base (if previously registered), or it will
prompt you to Enter Base ID to register the new Handset.
Charging of the Handset Battery Pack
The Handset of your i 5836 cordless telephone is powered by a rechargeable
battery p a c k . I t c h a r g e s a u t o m a t i c a l l y w h e n e v e r t h e H a n d s e t i s i n i t s
charger. Maximum talk time on a full charge is 8 hours, and maximum standby
time is 5 days.
You should charge the battery pack for 12 hours when you first receive your
phone. You'll know the battery pack needs charging when:
The Handset seems completely
dead, the LCD is completely clear
and does not activate when you
press the keys.