VTech i 5836 - Manual (Page 17)

15
Registration
Register Additional i 5801 Handsets
After charging, the screen will display:
Find the BASE ID Code by doing the following (Base
must be OFF):
1. At the Base, press MENU.
2. Scroll down to DISPLAY BASE-ID, then press OK.
3. Enter the 15-digit Base ID Code into the Handset. If you make a
mistake, move the joystick to the left (
) to backpace or press the
right softkey to erase a character.
4. Press OK to complete the registration process.
NOTE: If the Handset, after charging, Display Searching for Base..., press
the NEW soft key. Enter Base ID will now be displayed. Follow the steps
above.
Wait approximately 15 - 60 seconds. You will hear confirmation beeps from the
Base and Handset. The newly registered Handset will now be assigned the
lowest extension number not previously assigned to a different system Handset
(1 - 6).
If you do not enter the correct digit sequence, you will see Invalid Base ID! and
hear an error tone. move the joystick to the left (
) to backpace or press
the right softkey to erase a character, and carefully re-enter the Base
ID Code.
NOTE: The 15-digit BASE ID Code may contain numbers and characters,
including 0 through 9 and
**. Make sure you enter all 15 digits.
Congratulations! You can now enjoy the benefits of your VTech Multi-Handset
system.
Getting
Started
i 5886 manualNov11.p65 11/12/2003, 9:50 AM 15