VTech i 5836 - Manual (Page 16)

14
Registration
Register Additional VT 5820 Handsets
1. After charging the Handset, remove it
from its Charge Cradle; the screen will
display:
alternating with this screen:
2. If, after charging the Handset, you see:
3. Press NEW. You will now see the
ENTER BASE ID screen as described
in step 1.
4. Find the BASE ID Code by doing the following: (the Base must be in idle
(OFF) mode)
A.
At the Base, press MENU
B. Scroll down to DISPLAY BASE-ID
C. Press OK. The Base screen will display the 15-digit ID Code.
5. Enter the 15-digit Base ID Code into the Handset. If you make a mistake,
press
to erase a character. Then press OK.
NOTE: The 15-digit BASE ID Code may contain numbers and characters,
including 0 through 9 and *. Make sure you enter all 15 digits.
6. Wait approximately 15 to 60 seconds. You will hear confirmation beeps
from the Base and Handset. The newly registered Handset will now assign
itself the lowest Handset number not previously assigned to a different
system Handset (1 - 6).
7. If the Handset displays REJECTED BY BASE or continues to display
SEARCHING FOR BASE for well beyond 60 seconds, try the registration
process again by repeating the above steps.
Registration
Getting
Started
i 5886 manualNov11.p65 11/12/2003, 9:50 AM 14
Your i 5836 Handset comes registered to the Base Unit. To register
additional VT 5820 / i 5801 Handsets, follow these steps: