VTech i 5836 - Manual (Page 37)

35
Basic
Operations
Base Settings
To access Base Settings, with the Base in the idle (OFF) mode, press MENU, scroll
down to BASE SETTINGS, then press OK. You can now access the following
setting options:
RINGER VOLUME
RINGER MELODY
KEYPAD TONE
TONE/PULSE
CONTRAST
LANGUAGE
Press CLEAR at any time to back out of Base Settings mode.
Ringer Volume
To adjust the Base Unit ringer volume:
• Press MENU. Scroll down to BASE
SETTINGS, then press OK. RINGER
VOLUME will be highlighted. Press OK
again. You will see a graph on the Base
display indicating the relative volume set-
ting.
• Press to lower the ringer volume.
At the lowest setting (graph is com-
pletely clear), the Base will not ring
when a call comes in.
• Press to raise the volume. At the
loudest setting, the graph is completely
shaded in.
• Press OK to confirm your setting.
Ringer Melody
There are eight Base ringer melody choices. To
change the melody:
• Press MENU . Scroll down to BASE
SETTINGS, then press OK. Scroll down
to RINGER MELODY.
• Press OK. Use either scroll key to
sample the melodies.
• Press OK to confirm your selection.
Base Soft Menu Functions
i 5886 manualNov11.p65 11/12/2003, 9:51 AM 35