Vertex Standard VX-8R - Manual (Page 157)

VX-8R O
PERATING
M
ANUAL
155
S
ET
M
ODE
I
TEM
81: SCAN LAMP
Function: Enables/Disables the Scan Lamp (while scanner is paused).
Available Values: ON / OFF
Default: ON
S
ET
M
ODE
I
TEM
82: SCAN RE-START
Function: Selects the Scan Re-start Delay time.
Available Values: 0.1sec ~ 0.9sec (0.1sec/step) or 1.0sec ~ 10.0sec (0.5sec/step)
Default: 2.0sec
S
ET
M
ODE
I
TEM
83: SCAN RESUME
Function: Selects the Receive-mode Battery Saver interval (“sleep” ratio).
Available Values: 2.0sec ~ 10.0sec (0.5sec/step) /BUSY / HOLD
Default: 5.0sec
2.0sec - 10.0sec: The scanner will halt on a signal it encounters, and will hold there for
the selected resume time. If you do not take action to disable the scanner
within that time period, the scanner will resume even if the station is still
active.
BUSY: The scanner will halt on a signal it encounters. When the signal drops,
the scanner will resume. The Scan resume time (default 2 seconds) is
controlled set by the Set Mode Item 82: SCAN RE-START.
HOLD: The scanner will halt on a signal it encounters. It will not restart auto-
matically; you must manually re-initiate scanning if you wish to resume.
S
ET
M
ODE
I
TEM
84: SENSOR DISPLAY
Function: Selects the sensor information when the transceiver is operating in the “Mono”
band mode with large characters.
Available Values: DC / TEMP / WAVE / BARO / ALTI / OFF
Default: DC
DC:
Indicates the battery voltage and battery type.
TEMP: Indicates the current temperature inside the transceiver’s case.
WAVE: Depicts the (RX and TX) audio wave-form.
BARO: Indicates the Barometric Pressure and relative changes in the pressure (two bars
per hour).
ALTI: Indicates the Altitude.
OFF:
Disables the sensor information (Indicates the “Current Time” only).
S
ET
M
ODE
I
TEM
85: SENSOR INFORMATION
Function: Indicates the information of the internal sensors.
S
ET
M
ODE
S
ET
M
ODE
S
ELECTION
D
ETAILS