Vertex Standard VX-8R - Manual (Page 46)

VX-8R O
PERATING
M
ANUAL
44
12. When you wish to add a beep tone into the beep melody
strings, move the cursor to the place where you wish to en-
ter the beep tone using the
/ key, then press the
key repeatedly until the “SELECT SELECT SELECT SELECT SELECT ” notation in the “Op-
eration Mode” slot turns into “INSERT INSERT INSERT INSERT INSERT ”. Now, press and hold in the key for one
second to add the new beep tone (Tone: “C2”, Tone Length: “500mS”).
13. Press and hold the key for one second to delete all data after the current position
that may have previously been stored in the User Beep Melody.
14. When you have programmed User Beep Melody, press the PTT switch briefly to save
the new setting and exit to normal operation.
You may check your work by monitoring the programmed User Beep Melody.
To do this, repeat steps 1 - 4 above, then press the
key.
S
PLIT
T
ONE
O
PERATION
The VX-8R can be operated in a Split Tone configuration via the Set mode.
1. Press and hold the key for one second to enter the Set Mode.
2. Rotate the DIAL knob to select Set Mode Item 94: SQL 94: SQL 94: SQL 94: SQL 94: SQL
SPLIT SPLIT SPLIT SPLIT SPLIT .
3. Press the key briefly to enable adjustment of this Set
Mode Item.
4. Rotate the DIAL knob to select “ON ON ON ON ON ” (to enable the Split
Tone feature).
5. Press the PTT switch briefly to save the new setting and
exit to normal operation.
When the Split Tone feature is activated, you can see the following additional parameters
after the “MESSAGE
MESSAGE MESSAGE MESSAGE MESSAGE ” parameter while selecting the Set Mode Item 95: SQL TYPE 95: SQL TYPE 95: SQL TYPE 95: SQL TYPE 95: SQL TYPE :
D CD D CD D CD D CD D CD : DCS Encode only (“DC DC DC DC DC ” icon will appear while operating)
TONE-DCS TONE-DCS TONE-DCS TONE-DCS TONE-DCS : Encodes a CTCSS Tone and Decodes a DCS code
(the “T-D
T-D T-D T-D T-D ” icon will appear during operation)
D CD-TONE SQL D CD-TONE SQL D CD-TONE SQL D CD-TONE SQL D CD-TONE SQL : Encodes a DCS code and Decodes a CTCSS Tone
(the “D-T D-T D-T D-T D-T ” icon will appear during operation)
Select the desired operating mode from the selections shown above.
CTCSS/DCS/EPCS O
PERATION
CTCSS/DCS/EPCS B
ELL
O
PERATION