VTech VT5875 - Manual (Page 10)

 www.vtechphones.com
G
ett
in
g s
ta
rte
d
Your phone can operate up to four handsets . To order additional handsets call the supplier .
To register your accessory handsets
1 . After charging the battery, the screen will display:
2 . On the base unit, press MENU/SEL, then scroll to DISPLAY BASE ID,
press MENU/SEL .
3 . Enter the 15 digit base unit ID code, If you make a mistake, press the
DELETE/MUTE key to backspace (delete characters), then enter the
correct information .
4 . Press MENU/SELECT to complete the registration process .
5 . Once a valid base ID code has been entered, the display will blank for
a second or two, and then show:
6 . If the base accepts the new handset, after several seconds the new
handset will show:
Where X is the new handset number assigned, sequentially, by the base .
Re-register existing handsets to a new base
1 . Install your new base unit, the handset(s) will display SEARCHING…,
press and hold the MENU/SELECT button for two seconds .
2 . The handset will display:
3 . Follow steps 2 through 6 in
To register your accessory handsets
above .
De-register all system handsets
1 . With the phone in idle, press *883# on the base .
2 . Then press MENU/SEL, IN USE and CHARGE, the POWER LED will
illuminate briefly before returning to idle.
3 . This will erase all handsets registered to the base . The handsets will
now prompt you to:
4 . Re-register the handset(s) to base by following steps 2 through 6 in To
register your accessory handsets above .
Registration
ENTER BASE ID
###############
SEARCHING...
HANDSET X
ENTER BASE ID
###############
• The 15-digit base
ID code may
contain numbers
and characters,
including 0
through 9 and * .
Make sure you
enter all 15 digits .
• If you do not
enter the correct
digit sequence,
you will hear an
error tone . Press
DELETE/MUTE
key to backspace
to erase a
character(s) and
carefully re-enter
the base ID code .
• De-registering all
system handsets
will prevent any
handset from
placing calls until
the handset is
re-register to the
base . ENTER BASE ID
###############