Veo 802.11b - Manual (Page 47)

Page 47 of 69
Restoring Factory Default
Settings
Press and hold the Power button down for 6 seconds to reset the camera to the
factory defaults. You will see “300” displayed in the IP Address LCD display to
indicate that the camera has been reset. Release the Power button to reset the
camera.
Appendix A
Note: You will need to reconfigure your camera settings after resetting the camera. The Veo
Observer will revert back to the factory default username (admin) and password (password) if the
camera is reset. The network settings on your camera will also revert back to DHCP, thus, you may
need to reconfigure the camera using the Observer Setup Utility. Refer to Chapter 5: Observer
Setup Utility for directions on configuring the camera’s settings.